Scantronic 8136 Guide de l'utilisateur télécharger pdf (Page 34)

34 of 44 496339 Issue 1

Table 2. Menu 04 Zone Status - IDIS Zone Messages.

Display Meaning

NORMAL Circuit and anti tamper loops are closed.

CCT Alarm circuit loop is open.

A/T Anti tamper loop is open.

CCT A/T Alarm circuit and anti tamper loops are open.

MISSING IDIS module or device is missing (see "6. Fault Finding -

Error Messages").

Table 3. IDIS Handheld Programmer Error Messages

OUT OF RANGE The module is blank or incorrectly programmed.

Carry on and try to program the module. If you do

not succeed then use a new device and return the

original to the manufacturer.

NOT IDIS ZONE You have tried to program a zone number less than

9. Zones 1 to 8 are FSL zones.

NO DEVICE FOUND There is nothing connected to the programming pins

on the IDIS Expander card.

DEVICE FAULTY The system failed to program the device. Try again

to program the module. If you do not succeed then

use a new device and return the original to the

manufacturer.

FREQUENCY ERROR The device or module is not programmed correctly.

Try again to program the module. If you do not

succeed then use a new device and return the

original to the manufacturer.

NON SCANTRONIC The module is not a Scantronic IDIS device. The

module cannot be used.

c) Check the current readings from the module. Table 4 shows a list

of possible readings.

These readings can be viewed from a remote keypad as follows:

Start Menu 04 in Programming mode and select Zone Test.

Enter the zone number and the keypad displays one of the

messages in Table 2.

Press Enter twice and the keypad displays the appropriate reading.

Press Menu twice to escape.

Simple Test Method 8136

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 43 44

Pas de commentaire

Scantronic 8136 Guide de l'utilisateur Page 34