Scantronic 8136 Guide de l'utilisateur télécharger pdf (Page 32)

32 of 44 496339 Issue 1

FSL Zone Status Error Messages

Z01:FSL STATUS 1K9 (TROUBLE)

Meaning: FSL Loop Resistance Wrong. The loop resistance on one of the

FSL loops is above or below the normal threshold Level. Zones in

trouble will not prevent a user from setting the system, however, the

system displays the 'call engineer' message when the user tries to

set the system.

Action:

• Test FSL Zone status. Possible causes are loose or corroded

connections and high resistance.

• Check all wiring and connections associated with the zone(s) in

trouble.

IDIS Error Messages

ZONE 09 MISSING

Meaning: Menu 33 IDIS zones ‘MISSING’. The end station has tried to

initialise all valid IDIS modules/sensors and has failed.

Action:

See "IDIS Fault Finding".

IDIS Fault Finding

If the IDIS system is programmed and connected but either doesn't work

correctly or is inconsistent then this section describes steps you can take to

isolate the fault.

Work on one loop at a time to avoid confusion. Faults on one IDIS loop do

not affect other loops provided you have not linked the loops remote from the

panel.

Use the Simple Test Method described on the next page if you have just one

or two faults per loop. In this case it is best to assume at first that faults are

located at the modules the system reports as faulty.

Use the Thorough Test Method on the following page if there are more than

two faults per loop, or the initialisation is inconsistent from one time to the

next.

Before testing run Menu 33 Initialisation a few times. If there are any faults

then the display shows the highest zone number as the first fault. You can

see any other faults by pressing the up arrow key (the A key). Table 1 shows

the meaning of the messages that might be displayed.

FSL Zone Status Error Messages 8136

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 43 44

Pas de commentaire

Scantronic 8136 Guide de l'utilisateur Page 32