Scantronic 808 Guide de l'utilisateur Page 20
- Page / 26
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
20 496235 Issue 1
Changing Access Codes and User Privileges (Menu 8)
You must start from menu 8 for all the facilities described in this section.
To start menu 8:
1. Key in the User 01 access code.
2. Press Menu followed by 8.
The display shows: 8-USER INFO
3. Press Enter.
The display shows: EDIT USR INFO
Changing User Codes
1. Start menu 8.
2. Press Enter until the top line of the display shows "U1-C****".
3. Press A or B until the display shows the user number whose access
code you wish to change.
The display shows (for example): U2-C****
4. Press Enter.
The display shows: U2-C_
5. Key in the four digits of the new user code and press Enter. Note that
the display shows " * " characters instead of numbers. This is to prevent
anyone reading the access code over your shoulder.
The display shows: CONF_
6. Key in the same four digits again.
After you key in the last digit the display
changes to show (for example): U2-DURSN
If the display shows: CODE MISMATCH
then you did not key in the confirmation correctly.
Press Menu and go back to step 4.
If the display shows: CODE IN USE
then another user already has that access code.
Press Menu and go back to step 4.
Setting Up a Duress Code
The system does not allow a user with a duress code access to any of the
special functions listed in section 4. In addition, the system will not let you
give User 01 a duress code.
1. Start menu 8.
2. Press Enter until the top line of the display shows "U1-C****".
5. Supervisor
- USER GUIDE 1
- 1. Introduction 3
- Using the Keypad 4
- About This Guide 5
- 2. Everyday Operation 6
- Final Exit 7
- Exit Terminate Button 7
- Instant Set 7
- Keyswitch Setting 8
- If the System Will Not Set 8
- Unsetting the System 9
- If You Have a Keyswitch 9
- 3. After an Alarm 10
- Customer Reset 11
- Engineer Reset 11
- Remote Reset 11
- 4. Special Functions 12
- 496235 Issue 1 13 13
- Testing the System (Menu 4) 14
- Walk Test 14
- Bell Test 15
- Changing Zone Names (Menu 7) 16
- Using the Log (Menu 9) 17
- 18 496235 Issue 1 18
- 5. Supervisor 19
- Changing User Codes 20
- Setting Up a Duress Code 20
- Giving a User Arm Only Access 21
- Allowing a User to Omit Zones 21
- Giving a User Log Access 22
- User Records 23
- 24 496235 Issue 1 24
- 496235 Issue 1 25 25
- Installer name: 26
- Day Tel: 26
- Night Tel: 26
- Part No. 496235 Issue 1 26
Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Scantronic 808
(44 pages)Canon XEED WUX6500 manuály
Uživatelské manuály a uživatelské příručky pro Datové projektory Canon XEED WUX6500.
Poskytujeme 2 manuály pdf Canon XEED WUX6500 ke stažení zdarma podle typů dokumentů: Uživatelský manuál
Commentaires sur ces manuels